Vutec SIK232 Interface - Instructions Bedienungsanleitung PDF herunterladen (Seite 7)

7 / 13

3.1.2. Configuration Strings

Configuration strings for the R2D7 are segmented into 3 parts:

* V ;

As with operating instructions, the first character is the header. This is always the

asterisk (“*”).

Next is the setting for the R2D7. The following is a table of valid commands:

V Print Version (followed by mode: R = Radio, B = Bus)

R Radio Mode (put system 7 in Radio mode)

B Bus Mode (put system 7 in Bus mode)

Finally, the terminator is either a semi-colon or the “CR” character.

3.2. Response Strings

Although the RP-Bus is not bi-directional, the R2D7 does report status information

back to the sender. The following table describes the responses for each event in the

R2D7:

Event Response

Power On “version, X-on”

Terminator Received “LF” if good command

“U” if command was not understood

“CR” after command was relayed to controls

Buffer Overflow “O”

Buffer In Empty “XOn” (Ctrl+Q), but only if XOff was sent

Buffer Is Half-Full “XOff” (Ctrl+s)

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Vutec SIK232 Interface - Instructions Bedienungsanleitung Seite 7