Vutec RR433 Radio Frequency Remote Control - Instruction Bedienungsanleitung PDF herunterladen (Seite 2)

Reset to Factory Default

NOTE: The following sequence will clear all paired transmitter security codes from the RR433 memory.

1. While the Program Mode LED is off, press and hold the “Press to Learn Transmitter” button until the

Program Mode LED blinks on, then off, then stays on (takes approximately 6 seconds).

2. Release the “Press to Learn Transmitter” button.

3. The Program Mode LED will stay on indefinitely until the first transmitter is paired.

Antenna Orientation

• Mount the RR433 with the antenna pointing horizontally, parallel to the floor or ground, to

maximize reception.

• Install in open area, outside of a metal enclosure, and at least 5 feet (1.5 meters) above

the floor or ground.

• Ideally, the antenna should be at least 9 inches (23 cm) from any metal surface.

• Effective range is 50 feet (15 meters) unobstructed.

• See the Optimum RF Reception Guide for additional information about antenna

placement and the range of RF transmitters.

Horizontal Orientation

Specifications

FACTORY DEFAULT

No paired transmitters. All five memory slots are cleared.

Program Mode LED stays on solid until the first transmitter is paired.

VERSION BLINKS

(at power up)

version 2 = 2 red blinks

version 5 = 5 red blinks

version 5.1 = 5 short and 1 long, red blinks

FREQUENCY

433.92 MHz

POWER

Supplied by +5VDC from modular connection to EYE or BUS port on RP bus motor

control or ESI accessory.

Current Draw = 25mA

DIMENSIONS (with antenna)

Length: 3.86 in. x Width: 3.83 in. x Height: 0.89 in. (98.1 mm x 97.4 mm x 22.8 mm)

PAIRING

Can pair with a maximum of five (5) transmitters.

Modular Connection

Program Mode LED

Press to Learn Transmitter

button

1 2 3 4 5

Keine Kommentare

Vutec RR433 Radio Frequency Remote Control - Instruction Bedienungsanleitung Seite 2